DTF Transfer Troubleshooting
Quick Troubleshooting Reference
| Problem | Likely Cause | Quick Fix |
|---|---|---|
| Peeling after press | Not enough pressure or time | Increase pressure, repress 5–10 sec |
| Dull colors | Low temp or under-pressed | Verify 300°F, press longer |
| Edges lifting | Uneven pressure | Repress with parchment |
| Not sticking to fabric | Incorrect material | Test on cotton first |
| Cracking after wash | Skipped repress | Always repress 5 seconds |
Detailed Troubleshooting Guide
Ready to start pressing? Read our guide.
Transfers Peeling After Pressing
This usually means the adhesive did not fully bond.
Fix:
-
Increase pressure to firm (level 7)
-
Repress for 5–10 seconds with parchment
Check your setup against your pressing instructions.
Dull or Faded Prints
This is typically a temperature or time issue.
Fix:
-
Confirm press is reaching 300°F
-
Ensure even pressure across design
Edges Lifting
Edges lifting usually means inconsistent pressure.
Fix:
-
Make sure garment is flat
-
Repress using a cover sheet
Fabric Issues
Some fabrics can interfere with adhesion. See our fabrics guide.
-
Test on cotton first
-
Avoid sublimated polyester
Preventing Issues
-
Always test before production
-
Keep pressure consistent
-
Follow correct pressing steps
- Use the correct temperature
