DTF Pressing Instructions

Applying DTF transfers is simple when the correct heat press settings are used. Rad Transfers prints press-ready transfers designed for vibrant color, strong adhesion, and long-lasting durability on cotton, polyester, and blended garments.

Follow the steps below for consistently rad results.

Heat Press Settings

Temperature: 300°F
Pressure: Firm pressure (about level 7)

These settings work well for most standard heat presses and apparel fabrics. Read more about specific heat settings.

Application Steps

Step 1

Place the transfer on the garment and press for 10 seconds at 300°F with firm pressure.

Step 2

Hot peel immediately after pressing. Remove the carrier film while the transfer is still hot.

Step 3

Cover the design with parchment paper or a Teflon sheet.

Step 4

Repress for 5 seconds to fully bond the design to the fabric.

This final press helps the print settle into the garment and improves durability.

Garment Compatibility

Rad Transfers work well on a wide variety of fabrics including:

• Cotton

• Polyester

• Cotton/poly blends

• Performance fabrics

• Most standard apparel used for t-shirts, hoodies, and sweatshirts

Read more about best fabric types for pressing.

Washing & Care Instructions

To keep your prints looking fresh:

• Turn garments inside out before washing

• Wash with cold or warm water

• Avoid high heat when drying

• Do not iron directly on the printed design

Turning garments inside out helps protect the surface of the print and keeps colors looking bright.

Pro Tip

Every heat press runs a little different. For best results, test on a spare garment first and adjust pressure or press time slightly if needed.

Once you dial in your settings, you’ll be pressing clean, vibrant transfers like a pro in no time.